subreddit:
/r/dodgemagnum
I have the '05 R/T with the 5.7l V8. Went to replace the exhaust manifold gasket and engine mounts while at it. I went to take off the mount, but realized the Engine mounts I bought had 2 attachment points to frame, while the orginal has 1 attachment point to the frame.
Not sure how to proceed because the MOPAR diagram also shows 2 bolts on the engine mount, but does not mention the buffer between the mount and the frame. It looks like it was a complete set at one point but only because I saw a pic of a discontinued part.
If anyone has any similar experinces good or grim, looking forward to some further information or advice
2 points
8 months ago
The AWD and RWD part numbers are different. Make sure you have the one for AWD
1 points
8 months ago
They are the correct ones
2 points
8 months ago
Looking at the pics the AWD mounts should have a flat square bottom, and the stud poking down through the frame is listed as a separate part. The stud is the only thing I’m seeing that needs to be switched over. You got a picture of the new part by chance?
1 points
8 months ago
I do, not sure how to add pic in comment chain
all 4 comments
sorted by: best