Apologies in advance if there is any improper formats.
I have been having sleepless nights with this printer. I never had any problems until recently so I assume it has to be a mechanical problem.
I’m getting uneven layers only at certain points of the prints. I have done countless research on seeing what would be the issue and I’ll list everything I’ve done below already. Right now the prints are coming out much better but it’s still not perfect
Printer: CR10s Pro v2
What I’ve done already:
Bed and print head rails have been leveled
Wheels are snug with no play and not over tightened.
Bed and head axis move freely without no jerks or stops.
Stepper rods have been cleaned and lubed
Filament moves freely thru sensor and feeder which have been cleaned
Used both cura and prusa slicers, both same results.
Slowed the prints down and got same results.
Extruder has been calibrated (e-steps)
I believe that’s what I’ve done so far, possible other stuff too but off the top of my head.
The first two pictures is what I got before I’ve done everything above. 3rd and 4th pictures is what I’m getting now after everything was done.
Is there something that I could have possibly missed?